EasyManuals Logo

Dea Digipro User Manual

Dea Digipro
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
14
In setting mode:
Press
followed by , the yellow LED blinks, then insert a new administrator code two
times (the admin code length must be the same as above): the sound “BI” indicates that the
Press to exit the setting mode.
3.11 Turn on/turn o the anti-removal alarm
In setting mode:
Press
followed by (the yellow led blinks), then press followed by , a long “BEEP”
Press followed by (the yellow led blinks), then press followed by , a long “BEEP”
Press to exit the setting mode.
Warning: The built-in buzzer will continuously beep if the photoresistor is exposed to light. The
buzzer will automatically turn o within 60 seconds when the light is no longer detected, or by
entering the admin code.
3.12 Turn on/turn o the bell
In setting mode:
Press
followed by (the yellow led blinks), then press followed by , a long “BEEP”
Press followed by (the yellow led blinks), then press followed by , a long “BEEP”
Press to exit the setting mode.
Warning: The bell in ZONE 2 is available if the bell function is on. Press
in standby mode, the
relay will active once, activating the bell.
Warning: If the bell is enable in ZONE 2, you can’t use cards or user codes.
3.13 Adding the master card (ZONE 1 only)
In setting mode:
Press
followed by , the green LED will blinks indicating that there are no master cards
stored, otherwise, if the LED turns red it means there is already saved data, press the
key
twice to clear the memory, at this point the green LED blinks, then swipe the master card, a
long “beep” will be heard to indicate that the addition was successful.
Press
to exit the setting mode.
3.14 Enter settings mode swiping the master card
To enter the setting mode:
entry;
To exit the setting mode, bring back the master card, the LED will turn green and you will hear
Warning: The access control will be locked for 60 seconds after entering a wrong code or the
swiping an invalid card for 5 times (both the keyboard and the card recognition won’t be available
during these 60 sec.).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dea Digipro and is the answer not in the manual?

Dea Digipro Specifications

General IconGeneral
BrandDea
ModelDigipro
CategoryIP Access Controllers
LanguageEnglish