DIGIRAD N
13
EN
5 SIMPLIFIED PROGRAMMING MENU
PROGRAMMING MODE ACTIVATION (Enter 1 + 3 for 5 seconds)
HOME (fi x white LED)
FUNCTION
1 fast blink
PARAMETERS
2 fast blinks
VALUES
Follow what is described in paragraph “6. AVAILABLE FUNCTIONS ”for an in-depth description
DEFAULT
1 Adding codes
1 Direct command
1
Single
code
3 fast blinks
Follow the
procedure
indicated in
points 6.6 and
6.7
/
2 Multiple command
2 Deleting codes
1 Single code cancellation
Follow the indicated procedure
in point 6.8
2 Total cancellation
3 INSTALLER code
1 Adding INSTALLER code
Follow the indicated procedure
in point 6.9
2 Erasing the INSTALLER code
4 Not available
//
5 Not available
9 Setting
1 Radio coding
1 HCS Rolling Code
12 Dip Switch
3 D.A.R.T.
2 Backlight logic
1 Always OFF
2
2 ON with low light
3 Backlight intensity level
1 Minimum
1
2 Low
3 Average
4 High
5 Maximum
4 Backlight time-out _ _ _ Enter seconds (1-255) 3
5 Command time-out _ _ _ Enter seconds (1-255) 5
6 Code length _ _ _ Enter value (2-8) 4
7 Sound feedback
1 ON
1
2 OFF
8 Factory reset
1 Reset of the settings only
/
2 Total reset
Once the programming mode has been activated (see paragraph 6.2) and the HOME level has been entered, it is possible to use the
DIGIRAD N keys to navigate between the various programming levels and modify the stored values.
• Use the numeric keys from 0 to 9 for numeric selections (function-parameter-value choice);
• Use the E key to confi rm the function or parameter and store the value;
• Use the C key to cancel (short press). It also allows you to return to the HOME level (press for 1 second), or completely exit
programming mode (press for 5 seconds).
Example - “Set Command time-out to a duration of 10 seconds”: In programming mode, enter: 9 E + 5 E + 10 E
Example - “Turn off Sound feedback”: In programming mode, enter: 9 E + 7 E + 2 E
In general, after changing a value in functions 3-4-5-9 it will automatically return to the HOME level.
In the case of functions 1 and 2, on the other hand, after adding (or deleting) the fi rst code and assigning a channel, DIGIRAD N will wait
for further codes so if you want to end the operation, you will need to press the C key to exit.
To Next Page
Loading...