Troubleshooting
• Linking is only required for 3-way and 4-way wiring congurations
• If at any point a switch blinks red, factory reset it and try again
• To exit linking mode at any point, press & hold the congure button
for 10 seconds to factory reset each switch before retrying
• If you have dead-end or other nontraditional wiring in your home,
you can nd wiring and setup instructions at deako.com/wiring
Factory reset
Press & hold the congure
button for 10 seconds (the LED
will be appear solid red).
2626 2727
To Next Page
Loading...