950693-00 14/06/19
EN
Instruction manual
Before using this appliance carefully
read the instruction manual.
respected.
experience in its use.
The manufacturer cannot be held responsible in case of
improper use or failure to comply with the instructions
for use and the safety warnings.
Overview and warnings
Cleaning and user maintenance shall not be made by
or other types than those indicated.
substances.
damaged.
has acid leaks.
Description of the starter
Controls, reports and accessories Fig.1
Jump starting
Use the appliance only as an emergency starter
to support the vehicle battery. Do not use it alone
instead of the battery.
belts and pulleys.
arc or cause incandescent metal splashes.
Sequence of operations
Starter battery must be fully charged (4 led lit).
Carefully follow the starting procedure, failure to
comply may affect the life of the appliance.
1
2
3 Verify the status of the led in the smart booster
cable:
Led START + Led ERROR blinking = starter
ready for use.
Led ERROR ON = The starter battery is too low:
charge the starter.
4 (+) battery
terminal and black charging clamp (-)
battery terminal.
connect the clamp to the battery terminal that is not
the battery and the petrol pipes.
5 Verify the status of the led in the smart booster
cable:
Led START ON = you have 30 seconds to start
the vehicle. After 30 seconds without starting,
the two led will return to the condition of step
3; disconnect and then reconnect the cable with
To Next Page
Loading...