Need help?Do you have a question about the Decathlon Kayak Itiwit X100 2P and is the answer not in the manual?
Connect pump to high-pressure valve and inflate bottom to 5 PSI. Ensure valve is closed post-inflation.
Locate high-pressure valves on side tubes. Inflate to 3 PSI. Note pressure relief valve function.
Use small diameter conical pump end to inflate the seats to 3 PSI.
Position seats using riptab areas on bottom. Secure gear in rear storage or on rear deck.
Slide fins into base and clip with pin. Kayak is ready for launch.
Rinse kayak, bottom, and seats with clean water. Open drain plugs to empty water.
Wipe kayak, seats, and bottom inside and out with a sponge or towel.
Deflate side tubes, fold bottom, then fold kayak in half. Roll up, tie, and place in bag.
Store dry, clean kayak in a shaded, dry area, avoiding significant temperature variations.
Identify pressure loss causes (temp vs. leak). Use soapy water to locate leaks and repair.
List of available spare parts (seats, bag, valves, repair kit) for purchase.
To Next Page
General
