Need help?Do you have a question about the Decathlon Kayak Itiwit X100 3P and is the answer not in the manual?
Locate high-pressure valve, ensure closed position, connect pump and inflate to 5 PSI.
Locate high-pressure valve, ensure closed position, connect pump and inflate to 3 PSI.
Connect pump with conical end and inflate seats to 3 PSI.
Position seats on bottom using riptab areas and secure equipment.
Slide fins into base and clip with pin. Boat is ready for launch.
Remove seats, rinse with clean water, open drain plugs, and tilt to empty.
Wipe inside and outside of kayak and seats with a sponge or towel.
Remove fins, deflate, fold, roll up kayak, tie, and place in bag with accessories.
Store dry, clean, shaded kayak away from significant temperature variations.
Check for temperature changes, use soapy water to find leaks around valves or punctures.
Lists available spare parts like seats, bag, valves, and repair kits for loss or breakage.
To Next Page
General
