Tab1e of contents
Chapter 5 Operating the machine
1. SWITCHING THE MACHINE ON AND OFF
Main disconnect switch ............................................ 5- 1
Locking the main disconnect switch ................................ 5- 1
Switching the machine on .......................................... 5- 2
Switching the machine off ......................................... 5- 2
Emergencystop .................................................... 5- 3
Restarting the machine after an emergency stop .................... 5- 3
2. CUTTER SPINDLE
Spindle clockwíse/conunterclockwíse rotation ...................... 5- 4
Selectíng the spindle speed ....................................... 5- 5
Starting the cutter spíndle ....................................... 5- 6
Stopping the cutter spindle ....................................... 5- 8
Selecting the speed range ......................................... 5- 8
Spindle speed - DECKEL slide rule ................................. 5- 9
DECKEL slide rule - English version ............................... 5- 11
3. CUTTING TOOL
Mounting the cutting tool (vertical spíndle) ...................... 5- 12
Mounting the cutting tool (horizontal spindle) .................... 5- 13
Mounting the arbor support bearing ................................ 5- 14
4. FEED RATE
Feed direction (roughing) ......................................... 5- 14
Conventional milling .............................................. 5- 15
Feed directions in conventíonal milling ........................... 5- 16
Feed direction (finishing) ........................................ 5- 17
C1ímb milling ..................................................... 5- 17
Manually controlled slide motions ................................. 5- 18
Headstock manual adjustment ............ ......................... 5- 18
Tab1e slíde manual adjustment (horizontal) ........................ 5- 20
TaЬ1e slide manual adjustment (vertical) .......................... 5- 20
Feed rate - DECKEL slide rule ..................................... 5- 23
Power requirement - DECKEL slide rule ............................. 5- 25
Selecting the feed rate ........................................... 5- 26
Starting/stopping the feed motor .................................. 5- 27
Rapid traverse .................................................... 5- 28
Headstockpower feed ......... .................................. 5- 29
TaЬ1e slíde power feed (vertical) ................................. 5- 30~
Tab1e slide power feed (horizontal) ............................... 5- 31
5. VERTICAL SPINDLE HEAD
Pivoting the vertical spindle head ................................ 5- 32
Typical applications .............................................. 5- 3~.
Setting the vertical spindle head to zero position ................ 5- 33
Pivoting the vertical spindle head to angular positions ........... 5- 34
Positioning the vertical spindle head for angular holes ........... 5- 35
Vertical spindle axial adjustment ................................. 5- 36
Typical applications of axially adjustable spindle ................ 5- 36
0-12
To Next Page
Loading...
