September 2020 13 Dectron DS Series – Outdoor OMM
Equipment Specific Data
Specific information for individual dehumidifiers is provided in the following methods:
Main Label (Pic. C.5): the
manufacturer tag attached to the
front of the dehumidifier includes
the dehumidifier’s most critical data:
General data including:
o Serial number
o Dehumidifier model
(nomenclature)
o Design room conditions
(air temperature and
humidity)
Operational data, including:
o Refrigeration
(refrigerant type,
charge, etc.)
o Electrical/airflow
(dehumidifier voltage,
CFM, etc.)
o Other applicable data
(pool heating,
space/auxiliary heating
features, etc.)
Labels and Stickers: attached when
applicable to the exterior and
interior of the dehumidifier to show:
External systems connections
location/direction
(pool/space heating, cooling circuits, condensate)
Air filter locations, quantity, and size.
Additional Info (warning, caution stickers, etc.)
Wiring Diagrams: attached to the interior side of the
dehumidifier, depict dehumidifier control and power
wiring.
Remotely installed condenser or cooler would have its specific information provided in similar manner (labels etc.).
Attention! Glycol Circuits.
Unless otherwise indicated, equipment fluid circuits (except for refrigeration and pool water circuits) such as heat
recovery loop, compressor glycol loop, boiler package, fluid cooler etc., are normally filled/to be filled with
water/glycol mixture; normally, rust inhibitor-infused food-grade propylene glycol is used.
Glycol mixture concentration is normally shown on Main Label – refer as needed.
To Next Page
Loading...