Styling attachments
（1） Concentrator
The concentrator enables you to direct the airflow at your hair that you
are styling.
Connect the concentrator by simply snapping it onto the appliance.
Disconnect it by pulling it off.
Cleaning &Storage
1. After use, immediately turn off the power switch and unplug the
power plug.
2. The appliance can be cleaned with a dry cloth.
3. The attachments can be cleaned with a moist cloth or rinsed under
a running tap.
4. Remove the attachments from the appliance before cleaning them.
Make sure the attachments are dry before using or storing them.
5. Never rinse the appliance with water.
6. Allow the appliance to cool and store it in a dry location.
7. Never wrap the cord around the appliance since this will cause the
cord to wear prematurely and break.
8. If the supply cord of this appliance becomes damaged the appliance
must be replaced by returning to the retailer from which the product
was purchased or a similarly qualified person in order to avoid a
hazard.
Troubleshooting of fault during use
Fault
Cause
Troubleshooting
Product
failure to work
The power socket of the
product is not energized.
Check whether the power
socket is in good contact.
The product is powered
off automatically due to
overheating.
Unplug the power plug and let the
product cool for a few minutes.
Before powering on the product
again, please check the air outlet
to make sure it is not blocked by
lint, hair and other debris.
The voltage of power supply
connected to the product is
inconsistent with the rated
voltage of the product.
Ensure that the voltage of local
power supply is consistent with
the voltage indicated on the
product model nameplate.
To Next Page
Loading...