deerma DX118C - Application Method - Handle Push Use; Assembly Steps

1. Press the dust panel frame switch to open the dust panel frame
before use, confirm that the dust panel frame is equipped with the
strainers, and the reassemble the dust panel frame. Check that the
part of the body are firmly connected, and set the power switch to
„0” (o) gear.
2. Open the buckle at the back of the main machine handle, align
the metal tube with the hole in the middle of the handle, insert the
metal tube straightly into the bottom, and then clamp the buckle on
the handle to the fixed block on the metal tube handle assembly.