Definitive Technology Bipolar SuperTower BP7002 User Manual

Instrudions:
1. Carefully lay the speaker on its front surface.
2. Place one of the stabilizer brackets in the rear slot provided. (Note: Stabilizer bracket will be flush with
bottom of base.)
3. Insert two screws provided and tighten them securely, being careful not to strip out material.
4. Repeat steps #2 and #3 for the other stabilizer bracket.
5. Remove the supporting feet closest to the stabilizer brackets and thread them into the brass insert in the
stabilizer brackets.
6. Carefully return the speaker to the upright position and adjust the glides (supporting feet) to level
the speaker.
Note: If desired, the four glides (support feet) may be replaced and the four spikes provided may be installed.
The four spikes or glides must be fully threaded into the brass inserts on the stabilizer brackets.
AVERTISSEMENT: Mesures de Securite Importantes
Pour rMuire les risques que Ie produit se renverse par inadvertance, quatre supports stabiliseurs avec vis de
montage ant ete fournis. Ceux-ci doivent etre installes sur la base du produit, dans les rainures appropriees.
Procedures d'installation:
Outils requis: Tournevis etoile (non foumi)
Pieces requises: Deux supports stabiliseurs (fournis), quatre vis (fournies)
Instrudions:
I. Coucher soigneusement Ie haut-parleur sur la face avant.
2. Placer un des supports stabiliseurs dans la rainure appropriee arriere.
(Note: Ie support stabiliseur sera egal au bas de la base)
3. Inserer deux des vis prevues a cet effet et seITer de fa~on ajustee en prenant garde de ne pas elirner les parois
du materiel.
4. Repeter les etapes #2 et #3 pour l'autre support stabiliseur.
5. Retirer les niveleurs (pieds de support) les plus rapproches des supports stabiliseurs et visser les niveleurs,
dans I'encolure de cuivre des supports stabiliseurs.
6. Relever soigneusement Ie haut-parleur dans sa position fonctionnelle et ajuster les niveleurs (pieds de
support) pour egaliser Ie haut-parleur.
Note: Les quatres niveleurs (pieds de support) peuvent etre remplaces, si desire, par les quatres pointes
foumies a cet effet.
Unpacking Your BP7002/BP7004/BP7006s
Please Inspect For Shipping Damage
Each loudspeaker leaves our plant in perfect condition. Any visible or
concealed damage most likely occurred in handling after it left our plant and
should be reported at once to your Definitive dealer or the delivery company that
delivered your loudspeaker. Please unpack your system carefully. Save all cartons
and packing materials in case you move or need to ship your system. Record the
serial number found on the back of the BP7002/BP7004/BP7006 in the appropriate
place
on your warranty card, answer all questions and send it in.
Positioning the Speakers in Your Room
It is important, because of the BP7002/BP7004/BP7006's unique bipolar (front
and rear) radiation pattern, that some simple set-up recommendations be followed
in order to assure optimum performance in your room. Please remember that
although
these recommendations are usually valid, all rooms and listening set-ups
are somewhat unique, so do not be afraid to experiment with the speakers.
Remember, whatever sounds best to you is correct.

Definitive Technology Bipolar SuperTower BP7002 Specifications

General

Brand	Definitive Technology
Model	Bipolar SuperTower BP7002
Category	Speakers
Language	English