Definitive Technology BP 10B User Manual

CAUTION Important Safety Instructions
To reduce the risk of the product inadvertendy tipping over, two stabilizer brackets, with mounting
screws, have been supplied. These must be installed in the base of the product, in the slots provided.
Installation Instructions:
Tools required:
Philips screw driver (not supplied)
Parts required:
Two stabilizer brackets (supplied)
Four screws (supplied)
Instructions:
1. Carefully lay the speaker on its front surface.
2. Place one of the stabilizer brackets in the rear slot provided. (Note: Stabilizer bracket will be flush
with bottom of base.)
3. Insert two screws provided and tighten them securely, being careful not to strip out material.
4. Repeat steps #t2 and '3 for the other stabilizer bracket.
S. Remove the two supporting feet elosest to the stabilizer brackets and thread them into the brass
insert in the stabilizer brackets.
6. Carefully return the speaker to the upright position and adjust the glides (supporting feet) to
level the speaker.
Note: If desired, the four glides (support feet) may be replaced and the four spikes provided may be
installed. The four spikes or glides must be fully threaded into the brass inserts on the stabilizer brack-
ets, as well as threaded into the two brass inserts at the front of the speaker enclosure.
AVERTISSEMENT Mesures de Securite Importantes
Pour reduire les risques que Ie produit se renverse par inadvertance, deux supports stabiliseurs avec
vis de montage ont 6~ foumis. Ceux-ci doivent atre install6s sur la base du produit, dans les rain-
ores appropri6es.
ProcHures d'installatlon:
Outils requis:
Tournevis 6toile (non foumi)
Pi~ requises:
Deux supports stabiliseurs (foumis)
Quatre vis (foumies)
Instrudlons:
1. Coueher soigneusement Ie haut-parleur sur la face avant.
2. Placer un des supports stabiliseurs dans la rainure appropri6e arriere. (Note: Ie support sta-
biliseur sera 6gal au bas de la base)
3. Ins6rer deux des vis prevues a eet effet et serrer de fa~on ajust6e en prenant garde de ne pas
6limer Ies parois du mat6riel.
4. Re¢ter Ies etapes'2 et'3 pour l'autre support stabiliseur.
S. Retirer Ies deux niveleurs (pieds de support) les plus rapproches des supports stabiliseurs et visser
les niveleurs, dans l'eneolure de euivre des supports stabiliseurs.
6. Relever soigneusement Ie haut-parleur dans sa position fonctionnelle et ajuster Ies niveleurs
(pieds de support) pour egaliser Ie haut-parleur.
Note: Les quatres niveleurs (pieds de support) peuvent etre remplaees, si desire, par Ies quatres
pointes foumies a eet effet. Les quatres pointes doivent etre entierement viss6es a meme les eneolures de
euivre des supports stabiliseurs, et eelles sur la fa~ade avant du haut-parleur.

Definitive Technology BP 10B Specifications

General

Brand	Definitive Technology
Model	BP 10B
Category	Speaker System
Language	English