Definitive Technology PROMOUNT 90

To Next Page

The ProMount 90 is intended for use with Deﬁnitive Technology ProMonitor,

ProCenter, Mythos Gem and Gem XL loudspeakers or similar loudspeakers with

-20 thread receptacles. Each bracket can support up to 10 lbs (4.5 kg). Do not

use a single bracket with any speaker weighing more than 10 lbs (4.5 kg). Use two

(2) ProMount 90 brackets with the ProCenter 1000 and ProCenter 2000.

Step 1

Loosen clamping screw with supplied Allen (hex)

wrench until ball pivot slides out. Be careful not

to fully remove the clamping hex screw

Step 2

Fasten the ball pivot to the

-20 threaded receptacle

on the back of the loudspeaker. Tighten the ball pivot

nut using a

" (11 mm) wrench.

Step 3

1. Using the wall plate as a template, mark the two

screw-hole positions on the wall where you wish

to mount the bracket.

2. If you are certain that there is a stud behind

the wall surface, drive #10 wood screws

(not included) through the wall and into

the stud (a).

3. If there is no stud behind the wall at the

chosen location, install wall anchors (not

supplied) into the wall by following the

wall-anchor manufacturer’s instructions (b).

PROMOUNT 90 USER’S GUIDE

Installation

ball pivot

clamping screw

ball pivot

nut

Need help?

Do you have a question about the Definitive Technology PROMOUNT 90 and is the answer not in the manual?

Summary

Installation

Loosen Clamping Screw

Loosen the clamping screw with the Allen wrench until the ball pivot slides out, but do not fully remove it.

Attach Ball Pivot to Loudspeaker

Fasten the ball pivot to the 1/4-20 threaded receptacle on the loudspeaker and tighten the ball pivot nut.

Mount Wall Plate

Mark screw positions, drive screws into stud or install anchors, using the wall plate as a template.

Connect Wires and Mount Speaker

Connect speaker wires, place ball pivot into clamp, tighten screw for friction, adjust angle, and tighten firmly.

Technical Assistance