To Next Page

To Previous Page

Your new ProSub 60 Subwoofer contains a built-in ampliﬁer and

sophisticated electronic crossover. There are several ways to install your

subwoofer. One setup is not considered “better” than another; rather,

each is a function of what type of entertainment system you own and

how you plan to integrate your components. Read the installation sug-

gestions below to determine which options best suit your needs. Please

take care to perform all wiring procedures with your system completely

powered down.

Subwoofer Installation

Unpacking

Each loudspeaker leaves our plant in perfect condition. Any visible

or concealed damage most likely occurred in handling after it left our plant,

and should be reported at once to your Deﬁnitive dealer or the delivery

company that delivered your loudspeaker. Please unpack your system care-

fully. Save all cartons and packing material in case you move or need to ship

your system. Record the serial number found on the back of the subwoofer

in the appropriate place on your warranty card.

Inputs/Outputs

Your Deﬁnitive Technology ProSub 60 subwoofer operates from either

high level (speaker-type) or low level (RCA-type) outputs on your elec-

tronics. Use the low level jacks when connecting the subwoofer to the

left and right low level or LFE output jacks of a receiver, a preamp or a

signal processor. Use the high level speaker terminal inputs to connect

the subwoofer to the ampliﬁer output (speaker) jacks of your receiver or

ampliﬁer. Use the high level output jacks to connect the subwoofer to a

pair of left and right main speakers. (See wiring diagrams.)

When connecting the subwoofer to your system, it is recommended

that you use high quality speaker cable and try to maintain cable runs of

the same length for the left and right channels. Should you perchance

experience any level of ground hum or noise, try plugging the subwoofer

into the same circuit as your ampliﬁer. Also, consult the

“Troubleshooting” section of this manual. To prevent accidental damage

to your subwoofer from overdriving the system, the subwoofer features

an internal overload protection circuit.

Definitive Technology ProSub 60 User Manual

Other manuals for Definitive Technology ProSub 60