EasyManua.ls Logo

Defort DCC-251N - Operation

Defort DCC-251N
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
GB
In ation of balls and toys
• Install the valve adapter (connector or needle for ball
in ation) on the nipple and latch the lock by pushing
the lever down.
• Connect the air hose with the adapter to the in ated
object.
• Connect the compressor to the car lighter socket.
• Turn the compressor on.
• When the required pressure level is reached, dis-
connect the compressor from the car lighter socket.
• Disconnect the air hose with the adapter from the
in ated object.
• Quickly close the air passage of the in ated object.
ATTENTION! Control air pressure in the in ated ob-
ject. Avoid excessive pressurization of the in ated
object.
Troubleshooting guide
1. The compressor is not started on
Blown-out fuse in the car
- Replace the blown-out fuse in the fuse box of the
car.
Poor contact in the lighter socket
- Clean the lighter socket with a non-metal object.
2. The compressor is working poorly
The car accumulator is discharged
- Start the car.
Poor contact in the lighter socket
- Clean the lighter socket with a non-metal object.
Cleaning
Every time after completion of work, it is recommended
to clean the body of the car compressor and its air in-
lets from dirt and dust with a cotton cloth or a napkin.
Persistent impurities must be removed with a cloth
soaked in soapy water.
It is prohibited to use solvents: alcohol, ammonia solu-
tions, etc. for dirt removal. These  uids adversely affect
plastic parts of the compressor.
To prevent failures
• Keep the compressor adapter clean. With the com-
pressor connected to the car cigarette lighter, in
case of short circuit, a life-threatening situation may
occur. Accumulator capacity is very high, so you can
get injured.
• Protect the compressor from overheating. Do not
cover the compressor with foreign objects while in
use.
Before connecting, please check
• If the adapter and the car lighter socket match;
• If the car accumulator voltage matches with the
compressor's characteristics;
• If the accumulator can provide 10 A;
• Absence of failures and breakdowns in the cable
and the adapter for the cigarette lighter.
OPERATION
First, check pressure in the in ated object. It can be
done with the manometer, installed in the compressor.
Just connect the hose of the idle compressor to the
in ated object.
Avoid excessive pressurization.
Do not place the working compressor in the car com-
partment.
Do not leave the working compressor unattended.
Switch off the compressor immediately in the following
cases:
1. If the adapter or power cable is damaged;
2. Smell of burning insulation appears.
ATTENTION! This compressor is intended for short-
time operation (not more than 10 minutes). Longer
operation of the compressor may cause its overheat-
ing and breakdown. If you need to use the compressor
longer, after  rst 10 minutes switch off the device and
let it cool down for 10 minutes before restart.
WARNING! The valve cover shown on the
2 be-
comes very hot during operation. Do not touch this
cover to avoid risk of burns!
In ation of car tires
• Place the car to ensure the lowest position of the tire
valve.
• Connect the nipple to the tire valve. Push the lever
down and  x the nipple.
• Check pressure with the manometer.
• Connect the compressor to the car lighter socket.
• When the required pressure level is reached, dis-
connect the compressor from the car lighter socket.
• Release the lock of the joining nipple and remove it
from the valve.

Related product manuals