MAINTENANCE
Lift-off oven door
The oven door may be removed to improve oven access during cleaning
Grasp the open door on both
sides near the hinges
Flip the retainer clasps up
and over the hook on the
upper hinge arm.
Maintain upward pressure
on the door to prevent the
clasps from disengaging
Lift the door upwards and
outwards until it is free of
the hinge housing
After cleaning, refit the door
in reverse order.
Removing the inner door glass
.
• The glass may be removed for cleaning
purposes by removing the two screws
which hold it in place.
• It is now possible to clean the inside of
the outer glass if required.
• Wash the glass in hot soapy water, rinse
and dry.
• Re-assemble by carefully locating the
rubber seal in the embossed groove
before fitting the glass. The glass is
marked “THIS SIDE TOWARDS
OVEN”.
• Re-fit the two securing screws.
Removing the side racks and shelves
• The side racks and shelves may be
removed for cleaning purposes.
• Slide the shelf out fully against the shelf
stop.
• Lift the shelf slightly and slide it out
• The side racks may be removed by
pulling the bottom stay slightly
downwards thereby dislodging it from
the retainer at the bottom centre. Lift the
racks free of the retaining slots in the
oven wall.
• Replace in reverse order of disassembly.
To Next Page
Loading...
Need help?
General
