Page 6
Replacing the light bulbs.
Glass cover
Retaining ring
Housing
Light bulb
• Switch off the electricity supply.
• If the bulb has recently failed, it
might still be very hot. Allow the glass
cover to cool before attempting to re-
move the bulb.
• Hold the glass cover and unclip the re-
taining ring by inserting a finger nail
along the outer edge and pulling down.
• Be careful not to let the glass cover fall.
• Replace the light bulb with a commer-
cially available OSRAM 12V 20W
(64425) or equivalent bulb.
• Take care not to handle the replace-
ment bulb with bare fingers as tran-
fered skin oil may shorten the life ex-
pectancy of the halogen bulb.
• Fit the glass cover in the retaining ring,
align the 3 clips to the slots and clip
back into place.
• Switch on the electricity supply.
• Select the fan speed you require.
• Push button 3 for high extraction level,
2 for medium and 1 for low. The fan in-
dicator light will glow and the fan will
operate at the selected setting.
• To switch off the fan, push the fan off
button marked 0.
• If required, you may illuminate the
cooking area by switching the hood
lights on.
• Leave the hood running for a short pe-
riod after the cooking has been com-
pleted to clear any smoke and odours.
Operation.
Lights
on/ off
Fan speed
Fan
indicator
light
0123
Fan
off button
To Next Page
Loading...
Need help?
General
