Page 9
Before operating, clean the inside of the freezer. (see “ Maintenance and Cleaning").
After the freezer has been cleaned, insert the plug of the Chest Freezer into the
wall socket. Adjust the thermostat knob to an average position. The green LED
must light up. Leave the freezer to work for about 6 hours without putting food
inside it. Freezing of fresh food will be acheived after a minimum of 20 hours of
operation (when there is uninterrupted power to the unit).
Note:
If you find that the lid of the chest freezer is difficult to open just after you have closed it,
this is due to the pressure difference which will equalize and allow for the lid to be
opened normally after a few minutes.
Operation
Control Panel
A. Themostat knob
B. Power indicator light (Green)
C. Fast freeze button (Orange)
The Control panel: This is on the front side of the freezer depending on the model (See
item 7 on page 7). On models without a control panel a thermostat adjustment knob is
located on the air grille on the rear of the freezer or on the side of the freezer depending
on the model.
The control panel comprises of:
1. Thermostat adjustment knob (A) – To adjust the inside temperature.
2. Green LED (B) – Shows that the freezer is supplied with electrical energy.
3.Orange button (C) – Fast Freeze (Depends on model) – by pushing this button, the
orange led lights up indicating that the freezer has entered into the "Fast Freeze" mode.
To exit the Fast Freeze mode push the button again, the orange led will go off. The
LED’s give information about the mode of operation of the freezer.
Models with a control panel:
Models without a control panel:
Thermostat adjustment knob (D, E) - To
adjust the inside temperature. (located on the
air grille which is situated at the rear of the
freezer or on the side of the freezer depending
on the model).
To Next Page
Loading...
Need help?
General
