14 / /46 EN
Installation
After determining hardness level of the
supply water:
If the hardness level of the supply water
is above 90 °dF or if you are using well
water, then it is recommended to use water
purification devices and special filters.
If the hardness level of the supply water is
below 13°dF, there is no need to use salt
in your dishwasher. If this is the case, “No
Salt Warning Indicator” (if any) illuminates
continuously on the panel of your machine.
If the water hardness level adjustment is set
to level 1, the “No salt warning indicator” will
illuminate continuously although it is not
necessary to use salt. If you use salt under
this condition, salt will not be consumed and
the Salt indicator will not illuminate.
C
If you move your house, it is
necessary to readjust water
hardness level of your machine
by considering the information
given above according to the
hardness level of the supply
water in your new location.
Your machine will display the
most recently adjusted water
hardness level.
To Next Page
Loading...
