How to fix a Defy DTL162 Washer when water does not drain?
If your Defy washer isn't draining, first check that the drain hose height is not over 100 cm. Ensure the drain hose isn't kinked or obstructed. Finally, inspect the water outlet for any clogs.
Why is my Defy DTL162 not spinning?
If your Defy Washer isn't spinning, check that the laundry is evenly distributed in the wash/spin tub and hasn't clumped to one side. Ensure the washer is on a level surface. Also, make sure the washer lid is closed properly and nothing is preventing it from closing.
Why is my Defy Washer making loud noises and vibrations when spinning?
Loud noises and vibrations during spinning can occur if the laundry isn't spread evenly inside the washer. Make sure to distribute the laundry evenly before starting the spin cycle. Also, check if the washing machine is level on a sturdy, flat floor and adjust the legs on the feet to ensure it is level. Remove any unnecessary objects around the washing machine that might be causing the vibrations.
What to do if my Defy Washer is not supplying water?
First, confirm that you pressed the Start/Pause button after selecting the water supply option, as water won't supply without this. Verify that the water supply tap is fully open. Inspect the filter net at the water supply hose connector for any clogs and clean it with a toothbrush if necessary. Also, check if the water supply is cut off and ensure that the water pressure isn't too low.
What to do if my Defy DTL162 has no power?
If your Defy Washer has no power, check for a power failure in your area. Inspect the fuse or circuit breaker to see if it has blown or tripped. Make sure the power cord is securely plugged into the outlet.
What to do if the water drains out of my Defy DTL162 immediately?
If the water drains out of your Defy Washer immediately, ensure that the drain hose is not positioned below 65 cm. The drain may also be clogged with coins or pins. Half fill the spin basket with water and try spinning again.
What to do if my Defy Washer does not work?
If your Defy Washer isn't working, ensure the washer lid is completely closed. If the Pause button is active, press the START/PAUSE button again. Check if the water has filled to the selected water level; low water pressure can extend the start time. Also, make sure the water supply tap is open.
How to stop water leaks at the hose connector of my Defy DTL162?
If water is leaking at the water supply hose connector of your Defy Washer, ensure the tap connecting part is not loose and repeat the assembly steps. Check the rubber seal on the water supply hose is correctly positioned and tighten it again. Straighten the hose if it's kinked. If the water supply is too strong, slightly close the tap. If the tap itself is leaking, it needs to be fixed.
How to thaw a frozen drain hose and spin basket in my Defy DTL162 Washer?
To thaw a frozen drain hose and spin basket, add hot water to the frozen water tap and remove the drain hose, then soak it in hot water. Pour hot water into the spin basket and let it sit for about 10 minutes. Place a hot water towel on the drain hose connector. After the drain hose defrosts, reconnect it and check if water drains properly.
To Next Page
General
