Page 5
Securing the water tube.
• Fasten the tube using the fastener A.
• Check that the tube is not twisted or kinked.
• Tighten all the joints, open the tap and ensure that there are
no leaks.
Connect the water tube to the refrigerator
• Remove the rear cover at the bottom back of the refrigera-
tor.
• Insert the fastening ring into the tube following the direction
of the nut.
• Insert the tube into the top of the water valve which is lo-
cated to the right of the compressor, and tighten the nut.
• Replace the rear cover, ensuring that the tube is located in
groove between the refrigerator and the rear cover.
Using the filter for the first time.
• Open the tap and check the clarity of the water after it has
passed through the filter.
• Some impurities lodged in the filter during the manufactur-
ing process may be visible.
• Run the water until all the impurities have been removed.
Complete the installation
• Plug in and switch on the electricity.
• Press WATER on the control panel for 2 to 3 minutes to
remove any air bubbles and water used during leak testing.
• Do a final leak and installation check.
• Thereafter, do not move the refrigerator from its installed
position.
Securing the filter.
• Fasten the filter holder in an easily accessible position ( i.e.
the left back of the refrigerator using double sided adhesive
tape or to the wall using a screw and wall plug) and clamp
the filter into the holder.
To Next Page
Loading...
Need help?
General
