Why is the galvanization temperature too low in DeguDent SOLARIS Medical Equipment?
If the galvanization temperature is significantly too low during the process with your DeguDent Medical Equipment, it could be due to using too much liquid, a defective heater, or a defective heater controller. Use the suggested liquid volume (set in user menu).
How to resolve 'EEPROM read error' on DeguDent SOLARIS?
If the DeguDent Medical Equipment displays an EEPROM read error, and the device number in EEPROM is not legible, enter the serial number in EEPROM using the ewi command. Alternatively, try restarting the unit.
How to fix a defective temperature sensor on DeguDent Medical Equipment?
If the DeguDent Medical Equipment indicates a defective temperature sensor, this is likely due to a hardware problem. Replacing the temperature sensor is the suggested solution.
Why is the menu very dark on my DeguDent Medical Equipment?
If the menu on your DeguDent Medical Equipment is very dark, the screen saver may be active. Use a control (button, control knob) to exit the screen saver.
Why does the selection move slowly on my DeguDent SOLARIS?
If the selection moves slowly or discontinuously on your DeguDent Medical Equipment, it could be due to an incorrect encoder type being selected. Use the eww command to adapt the encoder type in EEPROM to the actual hardware (optical encoder, mechanical encoder).
What to do if DeguDent SOLARIS Medical Equipment doesn't recognize the reference electrode?
If the reference electrode is not recognized by your DeguDent Medical Equipment, make sure that the reference electrode was placed and check its contacts. Also, ensure that the anode and galvanizing liquid are present.
Why doesn't galvanization start above 65°C in DeguDent SOLARIS?
If galvanization does not start on your DeguDent Medical Equipment despite a temperature display significantly above 65°C, the galvanization temperature estimate might be incorrect. Check the galvanizing temperature EEPROM value using the rhg command; adjust that value using the shg command if required.
What causes high galvanization temperature in DeguDent Medical Equipment?
If the galvanization temperature is significantly too high during the process with your DeguDent Medical Equipment, the heater controller may be defective. Replace the heater controller.
What to do if objects hit the beaker rim in DeguDent SOLARIS?
If objects hit the rim of the beaker as the slide is lowered in your DeguDent Medical Equipment, it could be due to using the wrong beaker (small rather than large) or incorrect positioning (outside rather than inside). Use the beaker shown on the loading menu.
What to do if the DeguDent SOLARIS Medical Equipment shows 'Motor malfunction. Move head up'?
If the DeguDent Medical Equipment displays a 'Motor malfunction. Move head up' error, it could be due to an obstacle. Try to remove any obstacles that may be hindering the movement. Alternatively, attempt to restart the movement.
General| Category | Medical Equipment |
|---|---|
| X-ray Tube Current | 7 mA |
| Focal Spot Size | 0.8 mm |
| Beam Limitation | Rectangular collimation |
| Source-to-Skin Distance | 20 cm |
| X-ray Tube Voltage | 70 kV |
| Power Supply | 50/60 Hz |
| Manufacturer | DeguDent |
To Next Page
