6 © 2000 Directed Electronics, Inc. Vista, CA
NOTE: When connecting this wire to a (-) parking light wire, a relay is required. See the following
diagram for the relay application.
This wire provides a (-) 200 mA output whenever the transmitter code controlling Channel 3 is received. This
output will continue as long as that transmission is received. Use for options such as 551T Valet® Start system,
529T or 530T power window controllers, etc.
IMPORTANT! Never use this wire to drive anything except a relay or a low-current input! The tran-
sistorized output can only provide 200 mA of current, and connecting directly to a solenoid, motor,
or other high-current device will cause it to fail.
Connect this wire to the optional domelight supervision relay as shown below:
IMPORTANT! This output is only intended to drive a relay. It cannot be connected directly to the
domelight circuit, as the output cannot support the current draw of one or more light bulbs.
H1/4 BLACK/WHITE (-) domelight supervision relay output
H1/3 WHITE/BLUE (-) channel 3 output
To Next Page
