© 2000 Directed Electronics, Inc. Vista, CA 5
starter kill harness (H3), 2-pin connector
______
______
primary harness (H1) wire connection guide
This wire supplies (-) ground as long as the system is armed. This output ceases as soon as the system is dis-
armed. This wire can be used to turn on an optional sensor or to control an optional accessory, such as a window
module or pager.
This wire should be connected to the (+) parking light wire, as described in the Finding the Wires You Need section
of this manual. This output is protected with a 10 amp fuse. Never increase the value of the light flash fuse. If
more current is required, use an external relay.
H1/2 WHITE (+) light flash output
H1/1 ORANGE (-) ground-when-armed 500 mA output
BLACK STARTER KILL OUTPUT
BLACK STARTER KILL INPUT
H3/1
H3/2
To Next Page
