19 - ENG
pRESSURE WASHER (FIG. 15)
1. Drain all water from high pressure
15
C
L
D
hose. Use hose storage strap (L) to
secure high pressure hose (C) for
storage.
2. Drain all water from the spray gun
and wand by holding spray gun (D)
in a vertical position with nozzle end
pointing down and squeezing trigger.
Store in gun holder.
3. Wrap up and secure detergent siphon
hose so it is protected from damage.
ACCESSORIES
DANGER: Risk of fluid injection. When using replacement spray wands or
guns with this pressure washer, DO NOT use a spray wand and/or spray gun/
wand combination that is shorter in length than what was provided with this
pressure washer as measured from the nozzle end of the wand to the gun
trigger.
NOTICE: The use of any other accessory not recommended for use with this tool
could be hazardous. Use only accessories rated equal to or greater than the rating
of the pressure washer.
SpECIFICATIONS
Model DCV2420
PSI Max* 2400 psi
GPM Max* 2.0 gpm
High Pressure Hose 25 ft. (7.6 m)
Presure of Inlet Water 20–100 psi
Inlet Water cold tap
Soap Consumption Rate 10% max
*RatedPressureandRatedWaterFlowiswithinmanufacturingtoleranceof
(+/- 10%).
In a continued commitment to improve quality, the manufacturer reserves the right
to make component changes, design changes, or specification changes when
necessary and without notice.
SERVICE INFORMATION
Do not return this product to your retailer. Please contact our customer service
department at 1-877-362-4271
To Next Page
Loading...
