Delem DA-65 - Page 11

Delem
V0303, 0.11
Parameter 12
In Position tolerance ............................................................................................ 9.18
9.2.3. Adjustment procedures ................................................................................ 9.19
9.2.4. Extra info and recommendations................................................................. 9.23
9.3. Additional part support axes........................................................................ 9.27
9.4. Analog part support ..................................................................................... 9.29
9.4.1. Introduction ................................................................................................. 9.29
9.4.2. Installation and adjustment of the DBT01 control card............................... 9.29
9.4.3. Parameters analog part support.................................................................... 9.32
Parameter 7
Min. value ............................................................................................................. 9.32
Parameter 8
Max. value ............................................................................................................ 9.32
Parameter 18
DA-min.................................................................................................................. 9.32
Parameter 19
DA-max................................................................................................................. 9.33
Parameter RF
Delay before retour factor................................................................................... 9.34
Parameter NR
Nbr. of units.......................................................................................................... 9.35
Parameter 14
Default value......................................................................................................... 9.36
Parameter SA
Safety stop angle .................................................................................................. 9.36
Parameter MS
Max. angle speed ................................................................................................9.36