Need help?Do you have a question about the Delem DA-69 and is the answer not in the manual?
General| Brand | Delem |
|---|---|
| Model | DA-69 |
| Category | Industrial Equipment |
| Language | English |
Step-by-step guide to access the machine parameter menu.
Basic parameters for Y-axis and press brake specifications.
Configuration and use of auxiliary axes.
Selecting connected modules and assigning axes.
Importance and procedure for backing up machine parameters.
Sets the maximum Y-axis value, acting as a soft limit.
Sets the minimum Y-axis value, acting as a soft limit.
Sets the reference position for the left Y-axis linear scale.
Sets the reference position for the right Y-axis linear scale.
Sets the reference height for Y-axis bend position computation.
Applies correction to Tool Reference for head-mounted punches.
Sets the total maximum allowed parallelism for the beam.
Defines the maximum allowed braking time for the beam.
Enables proportional pressure valve control calibration.
Sets the maximal tonnage of the press brake.
Sets the minimal tonnage of the press brake.
Sets the output deflection for maximum force.
Sets the output deflection for minimal force.
Programs a ramp to control the pressure output.
Sets the Y-axis speed during fast closing.
Adjusts the start of the braking ramp relative to the mute position.
Sets the Y-axis speed during fast opening.
Adjusts the start of the braking ramp relative to the UDP.
Sets the Y-axis speed during reference search.
Computes table deflection when a crowning device is connected.
Computes table deflection based on the inertia of the under beam.
Computes table deflection based on the inertia of the upper beam.
Sets pressure for correct punch clamping.
Explains servo axis gain parameters for positioning optimization.
Sets the position gain factor for servo axis positioning.
Defines axis switching point from ramp to gain area.
Sets the servo axis braking factor.
Discusses parameters for optimizing AC-axis positioning accuracy.
Procedure for setting and adjusting crowning device positions.
Explains parameters for crowning device configuration.
Procedures for determining AD-values and adjusting control gains.
To Next Page
