Delem DA-69 - Part Support; 9.2 Digital Part Support; 9.2.1 Installation; 9.2.2 Parameters Digital Part Support

Delem
V0303, 0.10
Parameter PT
Positioning time ..................................................................................................... 8.6
Parameter P1..P4
Position 1...4............................................................................................................ 8.7
9. PART SUPPORT ...................................................................................................... 9.1
9.1. Introduction ................................................................................................. 9.1
9.2. Digital part support...................................................................................... 9.2
9.2.1. Installation ................................................................................................... 9.2
9.2.2. Parameters digital part support....................................................................9.4
Parameter 7
Min. Angle ..............................................................................................................9.6
Parameter 8
Max. Angle.............................................................................................................. 9.6
Parameter 18
Min. AD-value ........................................................................................................9.7
Parameter 19
Max. AD-value ....................................................................................................... 9.7
Parameter RF
Delay before retour factor..................................................................................... 9.8
Parameter SL
Nbr. of slaves .......................................................................................................... 9.9
Parameter 14
Default value......................................................................................................... 9.10
Parameter SA
Safety stop angle .................................................................................................. 9.11
Parameter MS
Max. angle speed ................................................................................................9.12
Parameter ML
Mean angle speed low.......................................................................................... 9.13
Parameter MH
Mean angle speed high ........................................................................................ 9.13
Parameter PN
Proportional gain min ......................................................................................... 9.14
Parameter PX
Proportional gain max......................................................................................... 9.14
Parameter FN
Feedforward gain min ......................................................................................... 9.15
Parameter FX
Feedforward gain max ........................................................................................ 9.15
Parameter DN
Differential gain min............................................................................................ 9.16
Parameter DX
Differential gain max...........................................................................................9.16
Parameter AM
Adjustment mode.................................................................................................9.17