Delem
V1101, 5.45
Parameter 86: Dc low speed
Range : 1 - 100
Default: : 4
Units: : %
Function
To program the low speed when a 2-speed DC-motor has been applied.
Description
It is possible to control a 2-speed motor drive through the analog output of the DM module. In
that case, high and low speed are recognised by two voltage levels which must be programmed
in the machine parameters. You have to program a percentage of the maximum output control
voltage which is +/- 10V.
This parameter refers to low speed of the negative direction movement.
To Next Page
Loading...
