Delem
V1101, 6.15
Parameter AR: Automatic R-axis correction (0/1)
Range : 0 - 1
Default : 1
Units : -
Function
This parameter serves to switch automatic correction of the R-axis position on or off.
Description
Normally the R-axis position is corrected to compensate for the crowning movement. This to
avoid collision between backgauge and die.
It may not always be necessary to adjust the R-axis position to compensate for the crowning
movement. In case of an hydraulic crowning, the crowning-pressure is built-up in the lower
machine table only during the pressing cycle. Since the backgauge is not moving during that
phase, there is no need to adjust the R-axis value. This parameter can then be used to have
automatic correction or not.
Press the key to select the required setting.
To Next Page
Loading...
