Delem DA-65 - Page 5

Delem
V0303, 0.5
Parameter 31
Closing speed incr. ............................................................................................. 3.31
Parameter 32
Closing ramp offset ............................................................................................3.32
Parameter 33
Del. before closing ..............................................................................................3.33
Parameter 34
Opening speed ....................................................................................................3.34
Parameter 35
Opening ramp offset .......................................................................................... 3.35
Parameter 36
Del. before opening ............................................................................................3.36
Parameter 37
Max. pressing speed ...........................................................................................3.37
Parameter 38
Delay before pressing......................................................................................... 3.38
Parameter 39
Delay before pressing force ...............................................................................3.39
Parameter 40 - 41
Not used............................................................................................................... 3.40
Parameter 42
Y-ref search speed .............................................................................................. 3.42
Parameter 43 - 45
Not used............................................................................................................... 3.43
Parameter 46
Closing brake ramp trim...................................................................................3.46
Parameter 47
Closing gain trim................................................................................................ 3.47
Parameter 48
Opening gain trim .............................................................................................. 3.48
Parameter 49
Pressing gain trim ..............................................................................................3.49
Parameter 50
Machine length between the cylinders ............................................................. 3.50
Parameter 51
Inertia under beam ............................................................................................ 3.51
Parameter 52
Inertia upper beam ............................................................................................ 3.52
Parameter 53
Not used............................................................................................................... 3.53
Parameter 54
Total machine length.......................................................................................... 3.54
Parameter 55
Punch clamp pressure........................................................................................ 3.55
Parameter 56
Die clamp pressure ............................................................................................. 3.56
Parameter 57