Delem DA-65 - Page 9

Delem
V0303, 0.9
Min. value ............................................................................................................... 6.6
Parameter 8
Max. value .............................................................................................................. 6.7
Parameter 15
Decimal point pos................................................................................................... 6.8
Parameter 18
DA-min.................................................................................................................... 6.9
Parameter 19
DA-max................................................................................................................. 6.10
Parameter 22
DA-out linear/table (0/1) .....................................................................................6.11
Parameter 23
Hysteresis.............................................................................................................. 6.12
Parameter 14
Default value......................................................................................................... 6.12
Parameter 31
Max computed value............................................................................................ 6.13
Parameter 31
Standard / high resolution (0/1).......................................................................... 6.14
Parameter AR
Automatic R-axis correction (0/1) ...................................................................... 6.15
7. DIGITAL OUTPUTS ................................................................................................ 7.1
7.1. Introduction ................................................................................................. 7.1
7.2. Digital R-axis............................................................................................... 7.1
Parameter 14
Default value........................................................................................................... 7.4
7.3. On/off outputs.............................................................................................. 7.5
Parameter NO
Number of FD outputs.......................................................................................... 7.6
Parameter LS
Ls FD output .......................................................................................................... 7.7
Parameter 14
Default value........................................................................................................... 7.8
8. I-AXES ...................................................................................................................... 8.1
8.1. Introduction ................................................................................................. 8.1
8.2. I-axis with 1 speed AC motor with potentiometer feedback ....................... 8.2
8.3. Digital I-axis parameters.............................................................................. 8.3
Parameter Nr
Nbr positions .......................................................................................................... 8.4
Parameter LS
Ls FD output .......................................................................................................... 8.5