Delem
V1101, 3.5
Parameter 5: Linear Scale Ref. left (Y1)
Range : 0.00-9999.99
Default : 25.00
Units : mm
Function
Y-axis left side linear scale reference position and parallelism adjustment.
Description
This value is displayed on the screen when the reference on the linear scale is passed. When the
reference marker on the linear scale is passed, a reference impulse is given to the electronics. (To
see left and right side separately switch service row on).
Note
This value must be greater than the mechanical travel distance on the scale from reference point
position to the scale end. This travel distance must also be greater than the mechanical travel of
the cylinder from reference point position to the upper dead point mechanical in the cylinder.
Make sure that when the cylinder is on the mechanical upper dead stop the Y-axis value read-out
is between 5 and 10 mm.
To Next Page
Loading...
