Delem
V1101, 3.12
Parameter 12: Max. Parallelism
Range : 0.00-50.00
Default : 2.00
Units : mm
Function
Total maximum allowed parallelism of the beam.
Description
The parallelism is the difference between the left hand cylinder (Y1) and the right hand cylinder
(Y2). For the controls there are two parameters that influence the beam parallelism:
1. Parallelism programmable under the programming parameters. This value has effect over
the entire stroke of the beam.
2. Parallelism programmable in data preparation, data editing and manual mode. This value is
taken into account when the beam reaches the clamping point and stays active until the
opening command (↑) becomes active.
The total parallelism is the sum of the values described under 1 and 2. When in automatic mode
a total parallelism that is greater than the max. parallelism is detected the control goes to stop
and the following warning is displayed on the screen:
** Parallelism > max. parallelism **
To Next Page
Loading...
