Deleycon MK897 User Manual

20 21
INSTALLING
The scope of delivery includes installation material for concrete surfaces. Other materials need
other installation material.
WIRING
CONNECTION
Switch on the mains fuse.
OPERATING
1. Adjust the time settings (TIME). This means how long the lamp is on after activating.
2. Adjust the photosensitivity (LUX). This means how fast the motion sensor reacts.
Motion sensors work by day and night. For daylight use, set LUX to maximum (SUN) for correct
work. If the lamp is more than 60W, the distance between the lamp and sensor should be 60cm at
least. The sensor and its connected lamp will have no signal at the beginning. After a Warm-up of
30sec, the sensor will start working.Note:
L phase (hot)
N zero conductor (ground)
USER´S MANUAL USER´S MANUAL
EN
OPENFACEPLATE
FIXEDARM
MOUNTINGHOLE
S PLAYBOLT
FIXEDARM
MOUNTINGHOLE
SPLAYBOLT
FIXEDARM
MOUNTINGHOLE
SPLAYBOLT
FIXEDARM
MOUNTINGHOLE
SPLAYBOLT
Three wire line Three wire line
Two wire line Two wire line
Two wire line Three wire line

Deleycon MK897 Specifications

General

Brand	Deleycon
Model	MK897
Category	Accessories
Language	English