7
•
Hold the helix housing (14) by the feed tube, with the wider opening facing upwards.
•
Insert the helix (15) (gear side rst) into the body.
•
Fit the selected pasta shaping disc (30) on the helix and fasten with locking nut (in clockwise direction).
•
Screw the fastening nut (18) on the body in the clockwise direction.
•
Plug the device in power supply and turn the speed knob to speed 3.
•
Feed the kneaded dough into helix housing’s feeder - the pasta will be extruded through the helix housing’s outlet
•
In case of the dough sticking to the inner wall of the helix housing, you can use meat mincer presser to push the dough into the helix housing.
•
Clean the parts as described under “Cleaning”.
9) CLEANING
•
Before cleaning, unplug the device from power supply.
•
Never immerse the main unit in water!
•
Do not use any sharp or abrasive cleaning utensils or agents.
Main Unit
•
Only a damp cloth should be used to clean the outside of the housing. Do not use any solvents.
Components
•
Steel grinding discs (17) require extra care to prevent them from rusting. To prevent rust on the metal grinding discs, it is recommended to wipe them until completely dry after washing
and store them covered with a light coating of oil or grease. Wash well before every usage.
•
MEAT & SAUSAGE SET: Helix housing (14), locking nut (18), helix (15), grinding discs (17) are NOT DISHWASHER SAFE. Wash them under warm soapy water and dry them
completely with a cloth.
•
It is highly recommended that all other components are cleaned under warm soapy water and dried thoroughly immediately after. If put in a dishwasher, low temperatures should be used.
•
Allow the parts to dry thoroughly before reassembling the device.
Cleaning list
Cloth Water Dishwasher
Cleaning list
Cloth Water Dishwasher
√ X X √
√
√ √ √ √ √ √
√ √ √ √ √ X
√ √ √ √ √ not recommended
√
√ √ √ √ √
√ √ √ √ √ √
√ √ √ √ √ √
X √
10) TROUBLESHOOTING
NO. Issue Possible olution
1
The machine doesn‘t work
·Check if the plug is properly inserted in power supply socket.
·Check if the rise knob springs back in place.
· if the machine has been working continuously for more than 6 minutes, allow the motor to cool down.
2
Noise in the mixing bowl when working (the accessory
scraped the bowl)
·Check if the mixing bowl is properly installed.
·Check if the accessory installed properly on machine.
To Next Page
Loading...