Replacing the U.2 fan
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working
inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1. Align and place the U.2 fan on the hard-drive assembly bracket.
2. Replace the two screws (#6-32x6) that secures the U.2 fan to the hard-drive assembly.
3. Connect the U.2 fan cable to the fan connector.
Post-requisites
1. Replace the left and right side-panels. See “
Replacing the side panels”.
2. Replace the stability foot.
32
To Next Page