Installing internal antenna (Location 1)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of an internal antenna and provide a visual representation of the removal procedure.
Steps
1. Remove the adhesive tape from the internal antenna assembly.
2. Remove the adhesive tape from the chassis.
3. Align the internal antenna assembly to the chassis.
4. Replace the screw (M3x3MM) that secures the internal antenna assembly to the chassis.
5. Route the antenna-cable (black) under the EMI shielding with a tool.
Next steps
1. Install the WLAN card.
2. Install the side cover.
44
Removing and installing components
To Next Page
Loading...
