Dell Dimension 2400 Series - Page 37


10. Turn off any attached devices and disconnect them from their electrical outlets.
11. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
12. Remove the computer cover.
13. Remove the password jumper.
Attach the jumper to only one pin so that you do not lose it.
14. Replace the computer cover.

15. Connect your computer and devices to electrical outlets, and turn them on.
16. If you are prompted to press <F1> to continue, press <F1>.
Back to Contents Page

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.