Dell Dimension 2400 Series - Page 9

9. Secure the filler bracket onto the end of the card with the screw you removed in step7.
10. Connect any cables that should be attached to the card.

See the documentation for the card for information about the card's cable connections.

11. Replace the computer cover.

12. Connect your computer and devices to electrical outlets, and turn them on.
13. Install any drivers required for the card as described in the card documentation.
Back to Contents Page

NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can cause damage to the equipment.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.