1. Remove the computer cover.
2. Remove the drive panel.
3. Remove the hard drive
and second hard drive, if applicable.
4. Remove the two front-panel screws.
NOTICE: Use care when handling the front-panel release tabs to avoid damaging them.
5. Using a small, flat-blade screwdriver, press the four top front-panel release tabs upwards and press down on the four
bottom release tabs to loosen the front panel.
6. Starting from the bottom of the front panel, pivot the panel toward the top of the computer and remove the panel.
1 top front-panel release tabs (4)
2 front-panel screws (2)
3 front panel
4 bottom front-panel release tabs (4)
Drives
Your computer supports a combination of these devices:
Up to two serial ATA hard drives
One FlexBay drive (may contain an optional floppy drive or an optional Media Card Reader)
To Next Page
Loading...
