Media Card Reader (Optional)
For information about using a Media Card Reader, see your Owner's Manual.
Removing a Media Card Reader
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.
1. Follow the procedures in "Before You Begin
."
2. Remove the computer cover.
3. Remove the drive panel
.
1 cable
2 Media Card Reader
4. Disconnect the FlexBay USB cable on the back of the Media Card Reader from the Media Card Reader connector on the
system board and route the cable through the cable routing clip.
To Next Page
Loading...
