Dell Dimension 8400 - Removing a CD;DVD Drive


8. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.

9. Enter system setup and select the appropriate Diskette Drive option.

10. Verify that your computer works correctly by running the Dell Diagnostics.
CD/DVD Drive



Removing a CD/DVD Drive

1. Follow the procedures in "Before You Begin."

2. Disconnect the power and data cables from the back of the drive.

3. Press inward on the two tabs on the sides of the drive, and then slide the drive upward and remove it from the drive bay.

NOTICE: To connect a network cable, first plug the cable in to the network device and then plug it in to the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.