21 DR4100 Best Practice Guide | April 2014
6.3.1.2 Configure DR1
1. Display the original configuration of DR1 using the following command:
network --show
2. Configure the DR to use the 1GB interfaces as bond0 members and free the 10GB interfaces for backup traffic.
a. Perform a factory reset of the network and then reboot the appliance:
network --factory_reset --auto_bonding_speed_1G
system –reboot
Automatic bonding speed: 10G
Device : bond0
Enabled : yes
Link : yes
Boot protocol : dhcp
IP Addr : 10.250.243.132
Netmask : 255.255.252.0
Gateway : 10.250.240.1
MAC Addr : BC:30:5B:F3:22:70
MTU : 9000
Bonding options : "mode=balance-alb miimon=100 xmit_hash_policy=2"
Member Interfaces : eth2,eth3
Interface name : swsys-78
eth2 MAC :78:2B:CB:1B:4A:28
eth2 Max Speed :10000baseT/Full
eth2 Speed :10000Mb/s
eth2 Duplex :Full
eth3 MAC :78:2B:CB:1B:4A:29
eth3 Max Speed :10000baseT/Full
eth3 Speed :10000Mb/s
To Next Page
Loading...
