Option Description
Intel SST-CP Enable Intel SST-CP. This option is displayed if Performance Per Watt (operating system) or Custom (when
OSPM is enabled) system profiles are selected. It is set to Disabled by default.
Configurable TDP Enables you to configure the TDP level. The available options are Nominal, Level 1, and Level 2. This option is set
to Nominal by default.
NOTE: This option is only available on certain stock keeping units (SKUs) of the processors.
SST-Performance
Profile
Enables you to reconfigure the processor using Speed Select Technology.
x2APIC Mode Enables or disables the x2APIC mode. This option is set to Enabled by default.
Dell Controlled
Turbo
Controls the turbo engagement. Enable this option only when System Profile is set to Disabled.
NOTE: Depending on the number of installed processors, there might be up to fourtwo processor
listings.
Dell AVX Scaling
Technology
Enables you to configure the Dell AVX scaling technology. This option is set to 0 by default.
Number of Cores
per Processor
Controls the number of enabled cores in each processor. This option is set to All by default.
Processor Core
Speed
Specifies the maximum core frequency of the processor.
Processor Bus
Speed
Displays the bus speed of the processor.
Processor n
NOTE: Depending on the number of processors, there might be up to fourtwo processors listed.
The following settings are displayed for each processor that is installed in the system:
Option Description
Family-Model-
Stepping
Specifies the family, model, and stepping of the processor as defined by Intel.
Brand Specifies the brand name.
Level 2 Cache Specifies the total L2 cache.
Level 3 Cache Specifies the total L3 cache.
Number of Cores Specifies the number of cores per processor.
Maximum Memory
Capacity
Specifies the maximum memory capacity per processor.
Microcode Specifies the microcode.
SATA Settings
You can use the SATA Settings screen to view the settings of SATA devices and enable SATA and PCIe NVMe RAID mode on your
system.
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
52
Pre-operating system management applications
To Next Page
Loading...
