Table 10. Status LED indicators and descriptions (continued)
Icon Description Condition Corrective action
out of range, or a failed
power supply unit (PSU)
or voltage regulator).
Memory indicator The indicator turns solid
amber if a memory error
occurs.
Check the System Event Log or appliance messages for the
location of the failed memory. Reseat the memory module. If
the problem persists, see the Support section.
PCIe indicator The indicator turns solid
amber if a PCIe card
experiences an error.
Restart the appliance. Update any required drivers for the
PCIe card. Reinstall the card. If the problem persists, see
the Support section.
NOTE: For more information about the supported PCIe
cards, see the Expansion card installation guidelines
section.
Appliance health and appliance ID indicator codes
The appliance health and appliance ID indicator is located on the left control panel of your appliance.
Figure 4. Appliance health and appliance ID indicators
Table 11. Appliance health and appliance ID indicator codes
Appliance health and appliance ID indicator code Condition
Solid blue Indicates that the appliance is turned on, appliance is healthy,
and appliance ID mode is not active. Press the appliance
health and appliance ID button to switch to appliance ID mode.
Blinking blue Indicates that the appliance ID mode is active. Press the
appliance health and appliance ID button to switch to
appliance health mode.
Solid amber Indicates that the appliance is in fail-safe mode. If the problem
persists, see the Support section.
Blinking amber Indicates that the appliance is experiencing a fault. Check
the Appliance Event Log or the LCD panel, if available on
the bezel, for specific error message. For more information
about error messages, see the Dell Event and Error Messages
Reference Guide at Dell.com/openmanagemanuals >
OpenManage software.
Overview 13
To Next Page
Loading...
