Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #1
● Phillips screwdriver #0
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to Screw type Quantity Screw image
Base cover Palm-rest and keyboard
assembly
M2 x 7 6
NOTE: Screw color
may vary depending
on the configuration
ordered.
Battery Palm-rest and keyboard
assembly
M2 x 3 2
Solid-state drive Solid-state drive bracket M2 x 3 1
Hard-drive assembly Palm-rest and keyboard
assembly
M2 x 3 3
Hard-drive bracket Hard-drive assembly M3 x 3 4
Left fan Palm-rest and keyboard
assembly
M2 x 3 2
Right fan Palm-rest and keyboard
assembly
M2 x 3 2
Wireless-card bracket System board M2 x 3 1
2
Removing and installing components 9
To Next Page
Loading...
