Table 5. System setup options—Advanced menu(continued)
Advanced
Default: Enabled
USB Emulation Enables or disables the USB emulation feature. This feature
defines how the BIOS, in the absence of a USB-aware operating
system, handles USB devices. USB emulation is always enabled
during POST.
NOTE: You cannot boot any type of USB device (floppy,
hard drive, or memory key) when this option is off.
Default: Enabled
USB Wake Support Allows you to enable USB devices to wake the computer from
standby or to disable the USB wake support feature.
NOTE: If USB PowerShare is enabled, a device
connected to the USB PowerShare connector may not
wake the computer.
Default: Disabled
SATA Operation Allows you to configure the operating mode of the integrated
SATA hard drive controller.
Default: AHCI
Adapter Warnings Allows you to choose if the computer should display warning
messages when you use AC adapters that are not supported by
your computer.
Default: Enabled
Function Key Behavior Allows you to set function key or multimedia key as the default
function key behavior.
Default: Multimedia key
Keyboard Illumination Selects the operating mode of the keyboard illumination feature.
Default: Bright
Keyboard Backlight with AC Selects the timeout value for the keyboard backlight when an AC
adapter is plugged into the computer.
Default: 1 minute
Keyboard Backlight with Battery Selects the timeout value for the keyboard backlight when the
computer is running on battery power.
Default: 1 minute
Battery Health Displays the battery health.
Camera Enables or disables the camera.
Default: Disabled
Battery Charge Configuration Set the battery charge settings with a preselected custom charge
start and stop.
Default: Adaptive
Advanced Battery Charge Configuration Enable Advanced Battery Charge Configuration from the
beginning of the day to a specified work period.
Default: Disabled
dGPU Support Enable the discrete graphics of the computer.
Default: Enabled
56 System setup
To Next Page
Loading...
