Removing the Power and
Volume-Buttons Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
Procedure
1 Peel off the adhesive tape from the hard-drive assembly.
2 Disconnect the power and volume-buttons board cable from the system
board.
3 Remove the power and volume-buttons board cable from the routing
guides on the speaker.
4 Peel the adhesive tape from the speaker.
31
To Next Page
Loading...
