6 Lift the connector latch and disconnect the Windows button-board
cable.
1 wireless card 2 antenna cables (2)
3 screws (2) 4 display-cable bracket
5 display cable 6 windows-button board
cable
7 adhesive tape 8 system board
7 Turn the computer over and open the display as far as possible.
CAUTION: Place the computer on a soft and clean surface to avoid
scratching the display.
8 Place the computer face down on a flat surface.
9 Remove the screws that secure the display assembly to the palmrest and
keyboard assembly.
55
To Next Page
Loading...
